UV Integrator 150 Products:
UV-Power of light source is registered by a Photodiode. A computer is transmitting the UV-energy
in electrical working units Joule. So the effective UV-quantity which is nessesary to harden a
UV-sensitive emulsion during a time can be deter- mined. The display shows this energie-rate in
Millijoule/cm2.
UV Integrator 150 HOW TO USE:
-By using the START-switch the integrator is ready to work..
-Integrator have to be put under the light source.
-After end of exposure you an read the UV-quantity during the exposure time.
-To reset the integrator you have to switch off.
-If the integrator is used in a UV-drying machine,you have to use heat-protection shiele.
Attention：in a UV-drying machine only to used with heat-protection shield
Attention：short time max. integrator temperature 0°- 110°C
Detailed parameters:
Model: UV-integrator (150)
Dimensions: Diameter 90mm high 12mm
Weight: about 140g
Suitable equipment: UV UV drying machine, exposure machine
Measuring range :0-5000mW / cm2
Energy Display: LCD 0-999,999 mj/cm2
Battery: Lithium battery 3.6V
UV measurement range :250-410nm (wavelength spectrum)
Power consumption: about 10,000 hours (Lithiwn lithium battery)
Working temperature: (degrees) 0-70 degrees
Installation / Operation
a. ON switch, the LCD (display) displays zero.
b. The energy meter UV lamp light source placed in the vicinity, as far as possible aligned with its back light source (due to the energy meter energy sensor
On the back), the exposure time for the appropriate extension.
c. On the display until the energy meter measurements show that there is, for example, 1,000 mJ / cm. (1000mj/cm2)
d. Turn off the energy meter switch (OFF), or the value of the display is set to zero.
Precautions
a. Avoid shaking the instrument.
b. Do not look or look through refraction / reflection UV lamp, ensuring anywhere on the body are not subject to UV irradiation.
Contact Us, E-mail: uv@ledwv.com
This product was added to our catalog on Sunday 18 August, 2013.
